Can-Am Maverick X3 Front Billet Capped Knuckle/Spindle Bearing Carrier - KcbKCB Offroad's X3 Front Billet Capped Knuckle Spindle Bearing Carrier is the pinnacle of UTV aftermarket manufacturing capability. The 7075 aircraft quality aluminum bearing carriers replace the stock snap ring and are designed to take a beating on the roughest terrain. These are beefed up the design at critical points to make an ultra strong, ultra lightweight solution to a common problem area on the X3. FEATURES (x2) X3 Billet Capped Front Knuckle

Get Your Smooth Ride Back

Note:  Verify jam nuts are tight and installed with thread locker

And we made it with an IP67 water-resistant rating

In the thought process of design for these arms we set out to address quite a few areas we felt needed vast improvement

It features a 12-position terminal block with integrated low-voltage cutoff battery protection

DRT Motorsports Can-Am Maverick R Aluminum Air Intake Vent is a must for riders who want better protection

Polaris RZR XP4 1000 Turbo

Uses scratch-resistant XR Optic hard coating

Balljoints and bushings not included

Designed and engineered through Class 1's racing program

- Rear Billet Crossover Rings for a fine-tuning crossover point

Finish: Mil-spec anodized with post-machined contrast cuts