WHAMMY ChassisA custom chassis for the WHAMMY project. Please note that the photos show the headphone jack, aluminum knob, and various other parts fitted. These parts are not in the chassis kit, and need to be obtained separately either by purchasing the WHAMMY Core Kit or using the part references noted below. Specifications Dimensions (HxWxD) Internal: 80x210x230 External: 86x230x243 Faceplate: 90x24x10 Materials Faceplate: 10mm aluminum Rear: 3mm aluminum Top

compared to most traditional vacuum tubes

Top cover: 2mm aluminum

Versatile Replace the pi resistors with inductors (not included) for CLC filtering

the feet were changed to aid in stability and a few parts values were updated

The plate is coated with a phosphor just like a VFD

Double sided 70um copper tracks

Some information from Cardas is below

No other solder flows as well

The designer OSTripper is active over in the Honey Badger General Discussion Thread which is where all the action is

It looks a bit like an old 40-pin DIP IC package

Includes NJM4580 Opamp

and a JFET input opamp from Analog Devices