Surface active agents. Determination of primary, secondary and tertiary amino nitrogen. Potentiometric titration

BS EN 15380-2 guideline assists you with code letters for the main product groups (MPG) i

Revision of recommendations for smoke and heat control

NOTE Z1 This standard has been written in particular to support EC Commission Regulation n° 1275/2008 for the measurement of off mode and standby mode power consumption

ISO 125 specifies the test procedure and apparatus which helps in conducting the tests

The purpose of this European standard is to provide means to enable manufacturers of machinery concerned by a radiation hazard to design and manufacture efficient safeguards against radiations

with the exception of their use in potentially explosive atmospheres

BS EN 61753-084-2 provides manufacturers with the definitions

the raw material supplier will have sufficient data to demonstrate compliance and warrant that the material is suitable for the specified application

for very small volumes

Authorities and law enforcement specialists

1   This guide provides methods and considerations for simulated soiling of reusable medical devices for the purpose of validating cleaning instructions

PD CEN/TS 13103‑2 provides the major phases for the design of an axle and describes the maximum permissible stresses applied on it