Link E-Throttle Accelerator Pedal Module (PED)An electronic accelerator pedal module used for drive by wire throttle control. Designed for use with Link ECUs supporting electronic throttle operation. What its used for Electronic accelerator input for drive by wire systems Replacing mechanical throttle cables Providing pedal position input for electronic throttle bodies Compatibility Link G4X Plug In ECUs (with E Throttle support) Link G4X Wire In ECUs (with E Throttle support) PCLink software

Designed for EJ-series turbo engines

with two output channels rated at 40 amps

Additional inputs and outputs available via auxiliary connectors

Passive or active ignition coils

GPS (antenna included)

Kvazer or Ecumaster are supported

This A loom is a 2

Link G4+ Fury (Loom B / Pin Kit B also required)

TEMP3 – Temperature input

Renault Clio 197/200 plug and play adaptor

Provides critical engine position data for accurate ignition and fuel control when used with Link ECUs

Building custom wiring looms using the C connector position