Bituminous mixtures. Test methods - Indentation using plate specimens1 Scope This document specifies a test method for measuring the indentation of mastic asphalt when it is penetrated at a given temperature, load and for a fixed time period by a standardized cylindrical indentor pin with a circular flat ended base. This document applies to mastic asphalt with aggregates of maximum nominal size less than or equal to 16 mm.

filamentary corrosion

legal protocols and restrictions in place that could influence how the process is applied

it is not possible to cover all potential hazards that may create an unsafe garment

provides just such information and has been cited as a reference in the UK National Annex to BS EN 1995-1-1

BS EN 12103 specifies the requirements for cork underlays made from agglomerated cork designed to be used in conjunction with any type of resilient floor covering to improve their acoustical performance and/or to provide a base for any rigid floor coverings

and service procedures

complementary or neutral in terms of the key objectives

a) combined circular sawing machines for firewood with additional units

This document gives guidelines for the determination by near infrared spectroscopy of constituents such as moisture

BS EN 12274-4 applies to slurry surfacing to be used in surface layers for roads

Capacitor graded manufacturers

EN 71-1:2014 on the safety of toys supersedes BS EN 71-1:2014 and combines three amendments into one which covers: