Carbon disulphide for industrial use. - Specification

BS EN 15330-2 discusses surfaces for sports areas — Synthetic turf and needle-punched surfaces primarily designed for outdoor use

a voltage of 1

night soil

BS ISO 8116-5 specifies the main dimensions

This part of ISO/IEC 1539 is an auxiliary standard to that defining Fortran 95 in that it defines additional facilities to those defined intrinsically in the primary language standard

4 Data Quality

and the state authorities

BS EN 13230-3 is the third part of the EN 13230 series defines technical criteria and control procedures for manufacturing and testing twin-block reinforced concrete sleepers

the conditions and the methods of measurement used to ascertain the performance of receivers within the scope of BS 6160-5 and to make possible a meaningful comparison of the results of measurements made by different observers and on different equipment

Hot dip galvanised steel products can be articles that have been batch hot dip galvanised (hot dip galvanised after fabrication) or articles consisting of continuously hot dip galvanised sheet which is then subsequently fabricated

This European Standard specifies the requirements for resin-bonded unfaced particleboards

BS EN 9131 defines the common non-conformance data definition and documentation that must be exchanged between an internal or external supplier or sub-tier supplier and the customer when informing about a nonconformity requiring formal decision