10 Inch Rack Mount for 2x 92mm Fans3D Printed rack mount for 2x 92mm Fans. The mount is 5mm taller then 2U to allow for the height of the fans. Now in a design to suit 10 Inch Racks! The Fans mount to the rear of the frame via the premade mounting holes. Note that screws to mount the Fans are not included. This listing is just for the Rack Mount, other photos showing Blanks etc are just for example. Does not include Rack Screws, Cage Nuts, or Network equipment. The 10 Inch range is

3D Printed 1RU rack mount for TP-Link Omada DS105G / TL-SG1005P switches

2) Unscrew the Back Plate from the Rack Mounting kit

NOTE: You will need to pair this with another ModMount item (Like a Blanking Plate) to make a full 1RU Width and screws are included to join them

The NUC slides into the mount from the rear and then is firmly secured by the rear retaining bracket

With both a Faceplate for mounting to your rack rails and a Backplate for additional support of your fans

all ports are accessible from the rear and the Touchscreen Rotary Knob is forward of the mount for easy access

3D Printed 1RU rack mount for the Unifi Switch 8 Lite PoE (Model: USW-Lite-8-PoE )

3D Printed 1RU rack mount for the Netgear GS108 Switch

This design comes in 2 forms

Your NUC's will slide into the unit from the front and all cables are accessible from the rear

The Cable modem slides into the frame by removing the backplate

) to make a full 1RU Width