Polycarbonate Lens for 6 LED Base PlateA high efficiency water clear power LED lens unit intended for use with the 6x LED round modules. A material with excellent thermal stability is required. Polycarbonate resins offer superior thermal stability compared to acrylic resins and can be used for continuous temperatures up to 120C. Specification Material Polycarbonate View Angle 45 Number of LEDs 6 Diameter 65mm Height 10. 6mm

It's a 2 Pin JST Cable Connector Female - 2

Removes solder faster with better heat response

Bright LED lights

The tail's 180-degree outward shape allows wire to be soldered easily

HW-516 Dual MOS tube control board replaces the relay module to trigger the cycle timing delay switch

It can be used either as a voltage mode or current mode controller

The most standard DC female jack is the 2

cloud server

Resistance Value 47 ohm Color Code Yellow

Connect the outer two pins to VCC and GND to use this potentiometer as a variable resistor

It is a MY2N-J 2A 8 Pin Power Relay

A small red and green bi-color 3mm light-emitting diode with a common cathode that produces consistent light and consumes little power