WIZARD POTTER THEMED DIE SET - Gina Marie DesignsMeasurements castle 2. 7x2. 4 Wand 2. 6x. 38 winged ball 3. 1x. 93 Die cutting tricks and tips! When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you

Putting it in flush can cause speed bumps on your machines roller and poor cuts in the future

Die cutting tricks and tips

Die measures approx 4x4 in size

You dont have to do this but if a die is proving a little more difficult it is good to try this

This die cuts best FACE UP and at an ANGLE

Largest layer measures 4x5

PLEASE NOTE this die is a smidge smaller than a 4

You can stamp out of order with some stamps and this is one you probably can but we did not want to confuse anyone :)

Measures approx 4

PLEASE READ -

So if the piercings are not as deep as you want use a paper shim

85 inches tall