Plastics. Extruded sheets of polypropylene (PP). Requirements and test methods1 Scope This International Standard specifies the requirements and test methods for solid flat extruded sheets of polypropylene homopolymers (PP H) and polypropylene copolymers (PP B and PP R) without fillers or reinforcing materials. This International Standard also applies to PP sheet in rolled form. It applies only to thicknesses of 0,5 mm to 40 mm.

4 a) and b) giving examples of probe positions for a structural L-joint has been corrected

BS EN 12504-1 does not give guidance on the decision to drill cores or on the locations for drilling or provide procedures for interpreting the core strength results

What is BS 7143 - Specification for catheter mounts (flexible adaptors) about

Who is PD CEN/TS 15448 - Interface between image controller and enrichment devices for

BS EN 61300-2-45 establishes the ability of a fibre optic component to resist degradation when exposed to water immersion which the component experiences during its service life

Safety of staff working on or near the railway track is part of the infrastructure manager safety management system and is not part of this standard

In conjunction with EN 1852-1

including environmental

This standard does not apply to active water trough barriers

With the help of this method

Who is BS EN 60371-1- Insulating materials based on mica for

The rated supply voltage does not exceed 1 000 V a