TiTAN Capped Steel Wheel Nuts - Toyota GT86 ZN6TiTAN Capped Wheel Nuts are made from steel and can be used in Motorsport. These are very durable wheel nuts and are made from high strength steel. Available in a wide range of colours. Sold in sets of 20. Note: These wheel nut heads are smaller than factory wheel nut heads and have a tapered seated fitment.

including instructions for a bolt-on installation

Audi RS3 Quattro 8V

culminating in a brake rotor that is perfectly matched to the highest braking demands of modern performance road and race cars

6 g/100g DIN 51575

Another huge positive is the almost instant brake obtained from SR after merely matching the pads to the rotors the brakes are right there from the cold up to 900°C (Ambient – 1650°F)

as well as an increase in frontal area to make the most of the air flow provided

After bedding ( up to 600-800 miles ) pads are silent

High friction formula improves brake effect by 15%

Laser cut heat shield helps protects from warm air

AIRTEC's solution to creating a direct replacement undertray in aluminium began with a full 3D scan of the vehicle’s underside to ensure a perfect fitment

0T EA888 Gen 1 (Requires 4x)

88 g/cm³ Viscosity at 40 °C 130 mm²/s