H2010R Steel Helical GearBoston Gears stock helical gears are manufactured in both right and left handed configurations with an industry standard 45 helix angle to transmit motion and power between non intersecting shafts that are parallel or at 90 to each other. For parallel shaft operation, helical gears with opposite hand helix angles are required. For shafts at 90, a same hand helix angles must be used. For parallel shaft applications, the overlapping tooth contact of our

self-centering design with mounting flange for use in through-bored components with smaller pitch/outside diameters

cutting to specific lengths or matching ends of two pieces of rack to create a continuous length longer than stock

They provide consistent high output torque even at low operating speeds

solid bronze bearing material

Max PV Value: 50

Bronze Bearing Type

when used with spur gears

Note: This is the spec sheet for the All Stainless version

self-centering design for use in through-bored components with extremely high torque and/or bending requirements

The riser blocks allow

Two-Piece Housing has rust-proof plated finish

Material: Nylatron