PBPH-BL-062 Heavy Duty Stamped Steel Pillow Block Mounted BearingHeavy guage two piece housing has rust proof plated finish. Housing is crimped together at bolt holes. Bearing insert with 2 set screws has longer inner race for added load support. Extra thick non conductive rubber liner corrects misalignment up to 2 while reducing noise & vibration. View Catalog Page

Porous flanged bronze bearing is press-fit in sturdy zinc die cast sphere with felt strip for lubrication

High axial load and torque capacity and does not mar the shaft

Ideal for washdown environments & is USDA approved

Traditional cost effective rigid coupling design provides torque transmission and alignment

Design fully engages the thread for secure locking

Interchangeable with most metal units

Collars include stainless steel screws

Effective on both hard and soft shafts

Step Down Adapters are ideal for making the shaft smaller

high impact & abrasion

Ball Bearing Type

Bearing insert with 2 set screws has longer inner race for added load support