Carburetor Fuel Inlet FittingEdelbrock part #8087 is a 6AN x 5 8" 20 Fuel Inlet Fitting for Edelbrock Square Bore & Carter AFB Carbs. This fuel inlet fitting is designed to replace the EPS carburetor's existing fuel inlet fitting, allowing the use of braided fuel line.

This new intake manifold is a single-plane Air-Gap design with a dual square-bore 4150 style throttle body pad

This upgraded pump maintains high fuel pressure

Each PROFORM 12

Washer and O-Ring seal

Notes: Fits 2/4 wheel drive with extended cab/short bed with 143

UMI's design eliminates the need to cut the valuable bed reinforcement rails

Upgrade to UMI tubular adjustable control arms for reduced wheel hop

of PTFE lined braided stainless hose

573" - Exhaust lift:

Constructed with 1

Save Money By Preventing A No Start Situation

When large amounts of torque are applied to the chassis