Link CAN Splitter Cable (CANTEE)This CAN splitter cable is used to connect two CAN devices from a single CAN connection point on a Link ECU or CAN loom. What its used for Splitting a single CAN connection into two CAN devices Connecting two CAN devices from an existing CAN loom or cable Compatibility CANJST CAN cable CANLTW CAN cable CANSS CAN cable Specifications DTM4 female connector to 2 x DTM4 male connectors Includes CAN high, CAN low, 12V, and ground wiring Loom 1 length: 80

Supporting accurate fuel injection control

Impedance: high impedance

Factory sensors and actuators connected via vehicle-specific adaptor

1 and M50B25TU DME 3

and boost control

A 4 bar absolute MAP sensor designed for accurate intake pressure measurement on high boost turbocharged and supercharged engines

← Back to ECUMaster Plug In and Plug and Play ECUs

by connecting it to your Link ECU

with software selectable 10K Ohm pullup and pulldowns

Adding CAN communication to compatible Wire-In ECUs

The T8+ features dual wideband lambda

Pin 8 – IGN3