Metallic materials. Tube ring hydraulic pressure test1 Scope This document specifies the ring hydraulic pressure test for metallic tubes. It is generally applied to tubes with an outside diameter greater than 120 mm and outside diameter to thickness ratio of not less than 20. The objective of this test is to ascertain the value of the hoop stress required to produce a specified total circumferential (hoop) strain.

7 Property values

Assessment of risk components for a structure

– description of electrical interfaces: capacity

BS EN 50443 applies to all metallic pipelines irrespective of the conveyed fluid

ensure proper interpretation of images

and to identify and analyse a comprehensive range of issues so that legal risks are proactively treated with the appropriate resources and supported by top management and by the right level of expertise

EN 61076-3-118 establishes specifications and test requirements for a connector with four contacts plus PE contact

Use when a customer asks for a third party to conduct an assessment in order to obtain a profile (basic

especially the assessment procedure for inspection by variables

Compliance with BS EN 14286 does not ensure compliance with national or international regulations

Structural engineers and designers

Some of the tests are: