T-Probe CalAmp Microfit 40 ftThis variation on the T Probe contains a DS18B20 and runs off of parasitic power with two wire connections: one for both power and data, and the other for grounding. The 40 ft cable is a 4 conductor CAT 5 E and is molded to the sensor using a low temperature thermoplastic for a sturdy joint. The sensor head is left exposed, which allows for quick and accurate temperature readings. The cable terminates with a 2 pin male Molex connector. The cable is

NOTE: Maxim Integrated Circuits reliability studies have shown that the device survives a minimum of 1000 cycles of condensation and drying

You can use your choice of word processing program: Word®

established at 23°C

as the radiant heat will become trapped inside the enclosure and will cause higher readings

url: '/products/ds1925l-f5'

which eliminates the strain point between the LinkUSB's™ electronics and the USB connector

Our calibration services will make your temperature sensors more accurate

02/27/2017 02:26:11 PM

The voltage can be sourced from most other sensors that produce a DC voltage signal in the range of 0 to +10 VDC

Approximate response and recovery times of the DS18B20 sensors can be found in Appendix One of the T-Sense manual

With an uncertainty of +/- 0

which is indicated by the “RP8” in the product name