2U Rack Mount for Minisforum UN1245 / UN1265 Mini PCs (Modular)3D Printed 2RU rack mount for the Minisforum UN1245 or UN1265 Mini PC! This is part of our ModMount Range, so you can mix and match your parts! You can even use this to mount 2 of these NUCs into a 2RU space! NOTE: You will need to pair this with another ModMount item (Like some Blanking Plates) to make a full 2RU Width, Screws are included to join the parts. This listing is just for the Rack Mount, other photos showing Blanks (Unless that option is

up through the bottom of the Mounting Tray into the HAT Standoffs

Side-Justified version here

TL-FC111PB-20 V2

The Mount is made from 2 Parts

Note: Fans and screws are NOT included

then slide your AMP in from the rear and then refasten the Back

The device slides into the mount from the front and cables are accessible from either the front or rear depending on how you orientate it

The device slides into the frame from the back after removing the back plate and there are 4 Keystone sockets that can be used to route cabling around to the front plate (Keystone Jacks and Fly leads not included)

The PC slides into the frame from the front with cables accessible from the rear

3D Printed 1RU rack mount for the Telstra Velocity / Opticomm Alcatel Lucent 7342 ISAM ONT

NOTE: You will need to pair this with another ModMount item (Like 2 Blanking Plates or another EQR6 Mount) to make a full 19" 2RU Width

Custom color