RyTek Marine Lowrance Splash ShieldOur RyTek Marine Lowrance Splash Shield work with our RTL1000 and RTL1010 transducer mounts. Featuring full Stainless Steel construction they cover the entire transducer and have a super easy installation! Install and adjust your transducer perfectly where you want it. Mark the installed location on the lower transducer bracket where the upper mount angle indicator is. Loosen the outside screws (just enough to slide the shield in between the screw and

(piece of pole not included)  You must re-use your existing transducer mounting screws/washers for attaching the transducer to the mount

5" tool pockets and two shallow mesh pockets for cell phones or other similar items) This narrow Caddie also works great for boats like the Impact lineup that has built in rod storage just below the Sport Track that will not allow the taller double row caddies to hang as nicely

v=zTU8hgrdztk&feature=youtu

It has almost 1/2" more up/down vertical travel

Replacement Toothed Serration Disk for our RTL3600 ActiveTarget Multi-View and Scout Only mounts

Once enough are confirmed I will contact you

the initial prototype (in the video below) had a thumb screw but to keep cost down and realizing the mount worked great without it

The bracket can be installed on the boat without having to pull the transducer cable from the boat (difficult and time consuming)

The #1 feature of our new RTH3600 Humminbird Mega Live Multi-View Transducer Mount is how quickly you change from Down/Forward View to Landscape View in basically the flick of your wrist

855 inches

The video below shows the original TripleShot transducer but the procedure is the same between the two

They are not 100% UV proof so they will fade slightly over time from being out in the elements and direct sunlight but will always keep that expensive transducer protected