Brush Drive Sprocket & Idler Sprocket for Eliminator 224 & Clipper M-2BFor Eliminator 224 & Clipper M 2B 16 tooth 5 8 bore 2 diameter steel sprocket. Two of these are used on all Eliminator 224 brush drive systems and on Clipper M 2Bs with updated gearbox brush drive systems. These sprockets are also used on Clipper M 2Bs that have the updated cable kit installed on the older brush drive system. 2 diameter

It may fit other clipper models as well

This Support bracket is for the Eliminator 224 Auger

Clipper recommends 5 balls per compartment

25" with CROSS SLOTTED holes

This pulley will also work on clipper 2b seed cleaners with the 13/16” shaft

This is the large gear on the clipper number 51 brush-drive system

The parts for the 13/16” brush carrier shafts are no longer available so if you Clipper m-2b still has 13/16” shafts it would be best to purchase our update kit because the 13/16” bore brush adjusting handle and shaft pivot collar is not made anymore

Single thread chain stitch

15” and 20” Drum Made from 7 Gauge Abrasion Resistant Sheet Steel

F911-80034

This is a standard length

so this belt is not always needed