Infusion equipment for medical use - Clamps and flow regulators for transfusion and infusion equipment without fluid contact1 Scope This part of ISO 8536 specifies requirements for non sterile clamps and flow regulators used as a subcomponent to control the flow of intravenous solutions and or blood components through sterilized infusion and blood transfusion sets and blood bag assemblies without fluid contact. In some countries, the national pharmacopoeia or other national regulations are legally binding and take precedence over this part of ISO 8536.

ISO/IEC 27033-5 gives guidelines for the selection

BS EN 60738-1-2 specifies the mounting test methods and characteristics for these thermistors

These requirements are not written with the objective of replacing a company’s internal operational and assessment requirements although they could be used as such

Who is BS 733-2 - Methods for calibration and use of pyknometers for

— type approval measurements of a vehicle

On fire safety in the design

Endurance testing for residential meters revised to reflect better the in-service life-

Since they store liquids in such high quantities these concrete structures need to meet

testing and safety devices and measures whilst considering environmental and maintenance requirements

Oil and gas industry

It also defines product families for establishing sterilization doses and gives details on a sterilization dose audit

Although many of the principles and methodologies recommended by the SCF are relevant within specific vertical sectors of cities