Textile-glass-reinforced plastics. Determination of mechanical properties on rods made of roving-reinforced resin - Determination of compressive strength1 Scope This part of ISO 3597 specifies a method for determining the compressive strength of composite rods of circular cross section made of roving reinforced resin. The test may be carried out on as moulded rods, or on rods that have been pretreated by immersion in boiling water (or another medium) for a specified time. The test is intended for inspection and quality control of rovings or for evaluating their suitability for use in a resin system.

Why should you use BS EN 622‑4 on Requirements for soft boards

ISO 4267-2 defines the various terms (be they words or symbols) employed in the calculation of metered petroleum quantities

In situations where the specifying organization agrees to apply these tests to products with higher voltages and power ratings

Section 2: General auditing recommendations

film processing chemistry or computed radiography system is changed

BS EN 13771-2 applies only to performance tests conducted at the manufacturer's works or wherever the instrumentation and load stability for testing to the accuracy required is available

ISO 8100-1 and ISO 8100-2 address the requirements in many parts of the world

Combined roughness is a quantity that determines the level of excitation of wheel-rail rolling noise

The input noise current is

What is ISO 787-5 – Oil absorption value of pigments and extenders about

What is BS EN 13463-1:2009

If a clause or subclause is specifically intended to be applicable to me equipment only