Sway Bar Kit With Bushings, Front (SB008) And Rear (SB009)The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspensions SB028 front and rear sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, and coil spring rate. Manufactured from heavy duty, solid 32mm bar stock

VT1-13A) (non US)

These shocks are a direct bolt-on replacement for your vehicle and can greatly enhance its performance in various driving scenarios

Tested with factory sway bars and UMI sway bars

Or you can open up the hole ever so slightly and fit the nut/washer included and accommodate it

autocross and road race use

BMR Suspension wants you to take it back with its solid motor mounts for 2008-2009 Pontiac G8s and 2014-2017 Chevrolet SSs

Dexron VI requires a different approach to a conventional ATF formulation

Valving and Spring rate are spec'd out based on how your car is built

The upper control arms are adjustable to set and adjust the vehicle's pinion angle for optimal performance

Polyurethane bushings at both ends eliminate bushing deflection without compromising ride quality

Our replacement bushing end features threads fabricated from 4140 Chrome Moly steel

This design gives you an incredibly strong control arm that greatly improves performance