4x4 FLOWER CORNERS DIE - Gina Marie DesignsDie measures 4x4 in size When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and larger

Largest approx 5

Please note one of the STAMP sentiments has a "rustic" look to it

Believe it or not most cutting machines say to cut with the die facing up

This is a 3 piece die set

4x4 in size

The inner lattice panel is VERY tiny and petite

ONLY THE STAMPS ARE INCLUDED

By rustic we mean that the font on one sentiment has a little distressed look to it

25 A2 sized

85 inches tall

Prior to shimming a die if needed try to remove the "outer paper" and run the die back through your machine

leaves a 1/8th border on an a2 card