Wrought aluminium and aluminium alloys. Sheets, strips and plates - Mechanical properties1 Scope In conjunction with ISO 6361 1, this part of ISO 6361 specifies the mechanical properties of wrought aluminium and aluminium alloy sheets, strips, and plates for general engineering applications. It applies to flat rolled products. The chemical composition of these materials is given in ISO 6361 5. The designations of aluminium and aluminium alloys and the temper designations used in this part of ISO 6361 are in accordance with ISO 2107. NOTE

Why should you use BS EN 13997 - Testing of connection and control accessories in irrigation systems

What is BS EN 15270 – Pellet burners for small heating boilers about

intended for leisure and entertainment

clinicians prescribing orthoses for patients

This document specifies the test procedures to obtain the essential characteristics of lithiumion cells for vehicle propulsion applications regarding capacity

BS EN 16681 also gives guidelines for the design of clad rack buildings in seismic zones

This standard defines in an abstract way the externally visible service provided by the Type 12 fieldbus data-link layer in terms of

Note: For the purposes of this document

BS 7305 exemplifies the methods used for the determination of tensile properties and an additional method for the determination of heat shrinkage using hot air of polyolefin tape yarns

Who is BS EN 61010-2-032 - Safety requirements for current sensors for

This part of ISO 15186 also describes the effect of flanking transmission on measurements made using the specified method

— month and year of manufacture