Aerospace series. Paints and varnishes. Cold curing intermediate coatWhat is BS EN 4476 Intermediate coat about ? BS EN 4476 specifies the requirements for an intermediate coat to be applied over a primer for aerospace applications and with a topcoat for aerospace applications on top. The properties specified in BS EN 4476 are obtained on defined aluminium alloy test pieces prepared in accordance with EN ISO 3837 and EN ISO 3270 and painted with primer. Topcoat is to be applied on an intermediate coat. The ability of

hazards caused by materials and substances and more

This part of ISO 16373 specifies a method for the detection and quantitative determination of the presence of carcinogenic dyestuffs as listed in Table 1 in dyed

users can develop and design current sensors

methods of testing and required test results for electric rudder angle indicators required to comply with clause 2

as shown in Table 1

BS EN 1709 sets the safety requirements that need to be met in relation to pre-commissioning inspections and the instructions for maintenance and operational inspections and checks of cableway installations designed to transport persons

This International Standard describes a method intended to determine the attachment strength of the top and bottom stops of a slide fastener

BS EN 60300-3-16 on dependability management maintenance support services guide is useful for:

BS 8587 provides owners

to the structure and use of the document

Who is ISO 20766‑20 - Filter unit of LPG fuel systems for

Note: 1: The disturbances produced by 400 Hz mains systems are not included in the scope of BS EN 61000-4-16