70850 Type 421-AG Studout™ Screw, Stud & Pipe ExtractorThe square shape of these extractors gives the tools the ability to remove broken bolts, screws, and pipes with minimum deformation of the broken part. These extractors will not chew up or expand the object being removed. To remove the broken threaded part: Drill a hole in the end of the broken part (left hand spiral heavy duty drills are recommended for this drilling operation), insert extractor, then turn counterclockwise using a wrench on the

Size 40- 18mm Diameter x 40mm Usable Length

• The outside hex configuration allows both wrench and die stock use in threading

By installing the preset units on a tool

• Morse Taper allows for quick conversion to twist drilling

68" Weight 0

tubing is Type A

USDA/FDA approved

Coilhose Pneumatics Nylon Tubing is extruded from high quality resin to close tolerances

converts rotary motion into linear motion

body and drill diameter for accuracy and high performance

Because the efficiency of a worm gear drive depends on the lead angle and number of starts on the worm

Splined Hub