4U Rack Mount for 5X Intel NUC -K PCs (Modular)3D Printed 4RU rack mount for up to 5 (or 10!) Intel NUC K (Low Profile) models. This mount was specifically designed for the NUC6i5SYK model, but will also work with any other NUC that shares the same dimensions. This is part of our ModMount Range, so you can mix and match your parts! You can even use this to mount 10 of these NUCs into a 4RU space! NOTE: You will need to pair this with another ModMount item (Like some Blanking Plates) to make a full

This listing is just for the Mifi Mount Mount

To install your Router

The Mini PC slides into the frame from the front with cables accessible from the front and rear

The Ultra slides into the frame from the front and all cables are accessible from the rear

3D Printed 1RU rack mount for the Teltonika TRB500 Industrial 5G Gateway

The device slides into the frame from the back after removing the back plate and there are 4 Keystone sockets that can be used to route cabling around to the front plate (Keystone Jacks and Fly leads not included)

The frame comes in 3 parts and the sides are connected to the main body with 10 Screws (Included)

There is also a Keystone socket on faceplate so you can pass the use a Keystone Jack (Not included) to re-route a port to the front

3D Printed 1RU rack mount for the Calix GigaPoint GP1101X GPON Modem

This listing is just for the Smart Bridge Mount

3D Printed 1RU rack mount for the HP Elitedesk 800 G2 Mini PC

3d Printed case for the DishyPowa V1