Shrink chuck 4,5° with cooling channels SK 50 - 08 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

With adjustable spray nozzles

clamping depth = -

With built-in tightening bolt All holders are made of forged steel

- Repeating accuracy 0

- After mounting

The caliper will be ready for measurements as soon as it is switched on with the LCD screen displaying the actual slider position

6 µm radial run-out with a 5 µm clamping nut

Low material loss

Bolt and Holding ring

Instructions for useWrench4 pcs

which can cause high frictional forces on the thread flanks

Metallic sealed Collets for internal cooling (applicable up to 100 bar)