GH2C-218-B Two Piece Clamping Shaft CollarEasily installed where major disassembly would otherwise be required. Design fully engages the shaft without marring. Recessed screw head provides safety with an outside surface free of major projections. Provides greater axial holding power than set screw or one piece clamping collars. Effective on both hard and soft shafts. View Catalog Page

Provides greater axial holding power than set screw collars

Traditional cost effective rigid coupling design provides torque transmission and alignment

Bronze Bearing Type

Entire unit is UHMW-PE

Includes 2 rubber grommets to reduce vibration & noise

USDA/FDA approved

Self-lubricating ideal for wet or harsh environments where wash down is required

Recessed screw head provides an outside surface free of major projections for safety

Bearing insert with 2 set screws has longer inner race for added load support

Ball Bearing Type

Acetal Copolymer collars will not rust or corrode

Housing is crimped together at bolt holes