End mill holder Whistle-Notch HSK 100 - 12 - 100Application: For mounting straight shank tools and inclined flat according to DIN 1835 form E (Whistle Notch). Delivery: With clamping screw and axial adjustment bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine

For sealing tools with internal cooling

parallelism: 0

Delivery: without inserts

Setting angle: 93°

ADJRGA = Length adjustment range

For longitudinal and plane turning

Collets sealed with seal for IC

With adjustable spray nozzle and shim

Hinged mounting device for toolholders

For safe clamping of taps

High flexibility: Large holding capacity up to –1 mm

which can cause high frictional forces on the thread flanks