Power LiftLift up almost anything you want with this linear actuator kit. It has a bolt pattern for the Versa Planetary gearbox with 1,2, or 3 stages (not included). Actuator stage has guide bearings to support moderate offset loads and can be sized to mount to 2x1 or 1x1 inch tubing on each side. Lead screw has 12. 7 turns per inch and the useful travel is approximately 13 inches long. Limit switches are included. Pictured motor, RS 7 encoder, controller are

17:32 (1:1

The main plates are 7075-T6 and the wheel module is 6061-T6 aluminum

67"OD X 15

Solidmodel - Turret Bearing

The slip ring is specially made for zero noise (contains mercury

Example Waveform

Installation Instructions

HTD pulley

Made of 6061 aluminum

The 2nd bevel gear is also 3/8" or 1/2" hex bore (same as input)

Order the required single pieces to make rectangular frame robots

These wheels work well for drawing balls towards the center then up over a bumper