LANTERN DIE SET - Gina Marie DesignsTips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this trick! Plate dies and

Keeping one plate new at all times helps the die not need to flex to two plates and only one

MEASURES 3

The wolf die in the card example is retired

You dont have to do this but if a die is proving a little more difficult it is good to try this

Believe it or not most cutting machines say to cut with the die facing up

ONLY THE STAMPS ARE INCLUDED

approx 4x4

TIPS AND TRICKS FOR DIE CUTTING -

please do not buy these dies

Smallest is 1

Largest layer measures 4x4

leaves a 1/8th border on an a2 card